Silvia Club of NSW
https://www.silviansw.com/forum/

Front bar installation
https://www.silviansw.com/forum/viewtopic.php?f=12&t=10763		 Page 1 of 1
Author:  Gebsta [ Wed Aug 11, 2004 8:18 pm ]
Post subject:  Front bar installation
Hey i just bought a Trial front bar and im just wonderin how im goin to put it in cos there doesn seem to be newhere to screw the screws in on the bar
Author:  nissanpower [ Wed Aug 11, 2004 8:23 pm ]
Post subject: 
dude, you have to drill your own holes if its a brand new bar
and use the brackets from the stock bar
Author:  Gamer [ Wed Aug 11, 2004 8:25 pm ]
Post subject: 
aftermarket front bars are sold with out holes. there is a bit of work fitting it. it aint all too difficult, take off your standard bar and use that as a referance as to where holes may need to be drilled. also, getting it to sit right is another kettle of fish all together.
Author:  Redline [ Wed Aug 11, 2004 8:31 pm ]
Post subject: 
You have to line up the holes and drill them youself (on the kit, not car! :D) just use the 2x "default" holes under the side section of the headlights, and the 2x holes on the lower side of the front guards.

Its quite difficult to secure in these positions so get your car jacked up and remove the front tyres, makes the job much easier.

Also depending on the kit design you may also have to remove the front support bar to get the front bar sitting on properly, try not to remove it if you dont have to.. I had no choice .. :cry:
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/