Silvia Club of NSW https://www.silviansw.com/forum/ |
|
piping question https://www.silviansw.com/forum/viewtopic.php?f=1&t=19919 |
Page 1 of 1 |
Author: | JoELMaN [ Thu Dec 22, 2005 9:13 pm ] |
Post subject: | piping question |
hey guys, ive just had a mount made up for my bov which is a peice of pipe 200 lg with a flange mounted off it, i got it made up at work out of mild steel my question is should i coat the inside of the piping with something? will it rust and eventually send little bits up into the engine? or will it stay clean on the inside? thanks |
Author: | Risking [ Thu Dec 22, 2005 9:38 pm ] |
Post subject: | |
It will be fine. Make sure you flush out the inside of the pipe before using it. |
Author: | JoELMaN [ Thu Dec 22, 2005 9:39 pm ] |
Post subject: | |
cheers dude, just wanted to make sure |
Author: | mokompri [ Fri Dec 23, 2005 12:08 pm ] |
Post subject: | |
does your work do fabrication work ? |
Author: | JoELMaN [ Fri Dec 23, 2005 1:45 pm ] |
Post subject: | |
well i work at onesteel and theres fabricators there, i just went to them for a favour, and they said no worries for a carton of beer |
Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |